MKS Gen V 1.4 3D Printer Controller Remix Board (RAMPS 1.4 + Mega 2560 Combine)
Specification
- MEGA 2560 and RAMPS 1.4 set on a board, to solve complicated RAMPS 1.4 combination of interfaces, the problem of failure prone.
- Support up to 5 motor driver (A4988 or DRV8825) .
- The circuit board with high-quality 4-layer, heat and made a special optimization; ramps are 2 shelves.
- Using high-quality MOSFET, and better heat dissipation.
- Using a dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps.
- Can accept 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems.
- The firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.
- Can be directly connected to the control panel and 12864LCD Ramps1.4,2004LCD control panel.
- Reserved for motor pulse and direction output ports for easy plug-in high-current To add a large current (eg 2A, 5A) motor drive circuit.
- Reserved Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs.
Reviews
There are no reviews yet.